Synology DS213AIR Guida di Installazione Scaricare il pdf (Pagina 7)

7 Chapter 2: Hardware Setup

b Slide the 2.5" Disk Holder into the hard drive bay, and push it all the way until the hard disk is connected

to the SATA connector. Secure the Disk Holder with the provided screws.

3 Repeat the steps above to assemble the other hard disk you have prepared.

4 Insert the disks in the order indicated on chassis, as shown below.

Note:

5 Replace the upper case, and tighten the screws on the back panel.

If you want to set up a RAID set, it is recommended that all installed hard disks are of the same size to make

the best use of hard disk capacity.

1 2 3 4 5 6 7 8 9 10 11 12 ... 22 23

Nessun commento

Synology DS213AIR Guida di Installazione Pagina 7